The flow of water in a place like home or
office is so necessary as you cannot just bring the water in the bucket all the
time. Now that you are living in the modern era, you cannot live your life in
primitive ways. Now for the flow of water the pipes are used and formerly there
were steel pipes but now there are pipes of plastic which are used for the flow
of water. Pipes & Pipe Fittings Dubai are providing solution to this with
the wide range of related things they have in store for you to purchase.
Choosing a pipe is also a task as you have
to go through the whole place where the pipe is needed to see how much length
is needed and where will the pipe bend and this is how the things are going to
be initiated for the purchase of pipe and then fitting it in the place. Now
that you have the idea how much length is needed all you need is to decide
which pipe will you use. In old days the steel pipes were used but now those
are replaced by the upvc pipes as they are giving more advantage.
And for the fittings there are a lot of
fittings that you can use to bend a pipe. you have to see that how much
fittings will you need and which fittings will be needed for the work. Now that
you have the idea how much will you need that fittings you just need to find
the right place from which you can buy all this and you have to be careful that
while choosing the fittings you must know that which type should you choose as
there are different types of the fittings of same name.
Now you need not to worry about it as Pipes & Pipe Fittings in Dubai are in the market and you can find all the types of
pipes and all the types of the fittings from them. They have all the kinds of
fittings some them are:
- Elbow
- Reducer
- Tee type
- Cross type
- Coupling
- Unions
- Adaptors
- Olet
- Plug
- Cap
- Valve
Now the functions of some of them are
mentioned below.
ELBOW: it changes the flow of the pipe and
they come in two angles of elbows. The 45 degree and 90 degree elbows. Both
serve the same function but the angle of bending is different.
REDUCER: these the fittings that connect
one pipe with other pipe and have opening bigger than the other. This is
because it connects a pipe with bigger circumference with the smaller
circumference. These come in two shapes, one is cone shaped and other is
parallel to the one side of the pipe and is squeezed from below to reduce the
air pressure.
TEE TYPE: these are like t-shape and these
are used to connect three pipes. They only have one angle of 90 degrees.
Similarly different fittings have different
purpose and you just need to make sure which one do you need.
No comments